QBD-mini Pockels cell drivers

QBD-mini-series consists of several Q-switch driver circuit boards that differ with output voltage range (up to 4.0 kV bipolar) and operating scheme (see also How to order? section). Please, note that by bipolar device an output pulse voltage U is formed by applying +U/2 to positive output wire and –U/2 to negative.

QBD-mini-series is specially designed to control Pockels cells by applying a fast switching high voltage. The modules require +24 V DC power supply and pulse generator to set an operating frequency. An output voltage level can be programmed in working range by user either manually (through onboard configuration trimpot) or automatically (applying a DC voltage to the respective pin).

There are two possible modifications of output signal type:

• push-up (= normally off scheme), when a base voltage level equals to zero
• pull-down (= normally on scheme), when pulses from base bias voltage to ground are generated.

The desired one should be chosen at the time of ordering and could not be changed by user.

QBD-mini-series is based on MOSFET technology and offers high repetition rates and fast transition time for a leading pulse edge. The recovery time by QBD-mini Q-switch driver is relatively long (5‑10 μs for the trailing pulse edge vs < 20 ns by QBU).

Performance

For instance, Q-switch driver QBD-mini-4016-UP/DN kept cool enough and running with proper load (Pockels cell with 5‑7 pF capacitance plus 30‑50 cm connective cable) has typical performance as below:

(*) The values are approximate, exact performance depends on actual load capacitance and cooling conditions.

In burst mode (i.e. for short term operations) the Q-switch driver performance increases approximately twice and exceeds 100 kHz at low operating voltages and low load capacitances.

The performance deteriorates for higher load capacitance.